Our products are 50x100x2cm.
Material - Eps Pricing - 1 Panel It adds value to your building and living space with its decorative appearance.
Provides image continuity at joints.
Thanks to the coating and mortar on it, you will not feel artificial.
It can be easily applied to any flat surface.
We have many color options.
It does not produce bacteria and is not affected by water and moisture.
Washable and wipeable.
It can be used on interior and exterior surfaces.
Provides thermal insulation.
It can be cut easily.
Since painted products are computer drawings, there may be minimal differences with the product photo.
To avoid tone differences in your painted products, be careful to purchase them in a single order.
Please keep in mind that there may be minimal tone differences when you order on different dates.
It is recommended to squeeze a few drops of marine glue into the joints.
Application Method: If you are going to apply it outdoors, weather conditions are very important.
It should never be applied in rainy, humid or very hot weather.
A shade net should be installed in weather with direct summer sun.
If it has rained, the wall should be allowed to dry in the sun for at least 2-3 days.
First of all, the surface must be prepared.
If it is under construction, at least rough plaster should be applied.
If it is a painted or plastered surface, it should be cleaned of dirt, if the paint is peeling, it should be scraped, notches should be removed with a hammer and gross concrete primer should be used.
You can use Svefix (Polyurethane jamb adhesive) or Karplus sheathing adhesive, thermal insulation board adhesive mortar, polyurethane board adhesive mortar (exterior), satin plaster or cekomastik (interior).
(You can use an equivalent product, but make sure it is a quality brand.) If you use Svefix, how to apply it is written in the application guide.
The foam adhesive is squeezed onto the material to form a rectangular shape with stripes in the middle, and it is allowed to cure for 40 seconds.
When it starts to cure, the material is glued to the wall.
If you are going to use Insulation Adhesive, just like tile adhesive, the adhesive is prepared with water and the amount stated on the product.
A comb is drawn behind the material, at least 2 cm, so that there is no gap left on the back surface.
The material should be laid from bottom to top.
If the bottom material does not touch the ground or there is a diameter on the ground, a flood profile should be used.
In this way, your material will be laid more evenly.
The material is placed at the desired location on the wall, slapped and ensured that it sits firmly.
After holding the material, you can move on to other material.
The material can be cut where necessary with the help of a knife or a saw.
